HOW TO ADD LED LIGHTING IF YOU DON’T HAVE THE PREMIUM LIGHTING PACKAGE
Update: Today I went and tried to remove the footwell lights again. This time it worked and I was able to attach the two remaining blue LED arrays easily. The cool thing is that I can easily remove and replace them with any other LED lighting I might want in the future : )
I followed some instructions on teslamotorsclub.com which used LED arrays that can be directly attached to already existing wires underneath the driver and passenger seats. I ordered them from amazon for a couple of bucks and had them installed in minutes. The hardest part is bending yourself in half trying to attach them to the underside of the seats….
The arrays can be easily attached to a little black wire that is situated under each seat. I ordered a set of four white and blue arrays and just installed the blue ones:
2 Comments
Leave a Reply
This site uses Akismet to reduce spam. Learn how your comment data is processed.
I see wires under the seats but no obvious connector. Can you give a little more detail on what to look for?
Hi Ron – i had the same problems as well. You just need to use a bright flashlight and carefully start pulling on the bunch of wires that are under the seat. Eventually you will see a black wire with a slim black plug that is not connected to anything. My wire was connected to the underside of the seat with a white plastic cable but I could pull it out further so that attaching the LED array was easily done.
Unfortunately taking pictures while lying down underneath the seat does not give great results. Just have a look again – maybe start with the other seat until you find the cable there and then go back to the other one. I hope this helps !